How do I turn the dinette table into a bed or traveling position? 

Please take a moment to watch the video below for step-by-step guidance, or follow the step-by-step written directions.

If you need additional help, our After Sales team at Escape Trailer will be happy to assist you. You can submit a support ticket using this form. 

Traveling Position

1. Remove the table from the mount

   • Locate the lever holding the table to the mount.

   • Undo the lever and carefully lift the table off the mount.

2. Secure the table

   • Place the table on the bed rails and brackets or another secure area to prevent it from swinging during travel.

   • Note: The table is heavy and can damage walls or trim if left on the mount during bumpy travel.

Adjusting the Table

1. Locate the levers underneath the table

   • There are multiple levers and screws. Loosening these changes how the table swivels.

2. Swivel the table (if needed)

   • Undo the top lever and slightly loosen the screw below it.

   • This makes it easier to swivel the table.

   • After adjustment, you can retighten, but it will not fully lock the table.

3. Adjust height for taller users (optional)

   • Locate the thumb lock on the arm.

   • Move the arm up and lock it to give extra height.

   • Loosen when not needed and store safely.

Converting the Table into a Bed

1. Locate the bed area

   • Position the bed with one corner facing the walkway; this helps with orientation.

2. Attach the brackets

   • Take the two brackets from the table (one on each side).

   • Slide them into the receivers on the bed frame.

   • You may need to adjust slightly to fit perfectly.

3. Adjust the table leg

   • Locate the small leg at the bottom of the table.

   • Fold it down and adjust to make the table level.

4. Add cushions

   • Place the angled cushion along the cut edge of the table.

   • Add a seat rest to complete the bed setup.

Tip: Always stow the table safely for travel and avoid leaving it on the mount to prevent damage.